Testing Equipments

This machine has been designed for Endurance testing of automotive lock, more specifically for 2 wheeler locks. The user for testing any configuration of lock can program the machine. The test sequence, number of steps, dwell time between steps, etc can be programmed by the user. Suitable fixture can be designed to accommodate physical variations of locks. Sensors are provided to continuously monitor the key insertion force and key turning torque. Limits can be set to detect excessive loads. A shower arrangement simulates rain by pumping contaminated water over the lock. The user can program the frequency of shower. The machine is totally automatic and the total number of test cycles can be set. The machine also has the provision to test the Voltage drop across the switch contacts.

This machine has been designed for High Voltage testing to measure the leakage current in the Power tools. The test is done at various voltages between various test points. Greasing of the power transmission train is done automatically if the power tool passes the HV test. The specified quantity of grease is dispensed automatically. If the power tool could fail the test the greasing is not done and the tool is returned to the loading / unloading station.

This machine is used for checking the weld strength of shock absorber assembly. The machine can apply load of upto 3 tons and the load can be varied infinitely by the used as per the requirement. The component to be tested is loaded manually and the test is initiated by pressing 2 buttons. The loading arm approaches the test component and applies a small preload and then starts applying the set load. Gauges are provided to indicate the load applied on the test component.